ECE 353 Introduction to Microprocessor Systems

ADuC702X Datasheet Rev A Errata:

Page 23, figure 15, the MS3-MS1 pin functions should all be active-low.
Page 33, figure 33, the external memory regions are 128kB, the ending addresses should be 0xX001FFFF, not 0xX000FFFF.
Page 42, Band Gap reference. The Internal Reference Output Enable bit in REFCON must be set to 1 whenever the internal reference is used. The reference will be unstable otherwise.
Page 63, left column, the COMTX register has only write access.
Page 71, left column, 3rd line should read "16 output pins".
Page 76, Timer 1. The T1LD, T1VAL, and T1CON registers are all 32-bits in length.
Page 79, table 78, the memory select pins are active-low.
Page 79, table 79, the memory regions all need to end at 0xX001FFFF, not 0xX000FFFF.
Page 80, figure 68, AE should be shown as active-high, MS0 & MS1 should be shown as active-low.

 

Copyright © College of Engineering, University of Wisconsin-Madison Content By: morrow@engr.wisc.edu